Stove and range installation in Ottawa

A range is the only appliance in most Ottawa homes that carries a 240-volt circuit or an open gas line, sits at child height, and gets pulled forward every time someone cleans behind it. That is why the installation rules for cooking appliances are stricter than for anything else in the kitchen.

A freestanding range needs its anti-tip bracket, or a child standing on an open oven door can bring the whole unit over. A gas connection needs the right flexible connector, a shut-off valve within reach, and a leak test, or a slow leak can accumulate behind the stove. A cooktop needs a cabinet cut-out to the millimetre and the right clearance to the cabinet below. We see the results of skipped steps on repair calls across Ottawa, and none of them are cheap to put right.

• The right cord and outlet. Many freestanding electric ranges arrive without a power cord. We fit the correct 3-wire or 4-wire 240 V cord for your outlet and confirm the outlet, wiring and breaker are rated for the range. Older homes in Alta Vista, Carlington and Overbrook may still have a 3-wire outlet, while newer Riverside South and Findlay Creek builds use 4-wire. Bringing the wrong cord is a common reason a new range sits unused.
• Wall ovens are hard-wired. Single and double wall ovens connect directly in a junction box, sit in a cabinet cut-out that must support their weight, and need the trim aligned to the cabinet face. We check the cut-out dimensions against the model before the old oven comes out.
• Anti-tip bracket. Fitted and engaged on every freestanding range, every time.
• Levelling and calibration. The range is levelled so oil sits evenly in a pan, and we confirm the oven reaches and holds temperature before we leave. If an oven runs hot or cold from day one, see oven temperature problems in Ottawa; a calibration offset is often a quick fix.

Gas work is where we are most careful. In Ontario, gas hook-ups are done by our TSSA-certified technicians: the appliance is connected with a new approved flexible connector of the right size, a shut-off valve is fitted or confirmed within reach behind the unit, every joint is leak-tested with solution or a detector, and each burner and the oven are lit and checked for a correct blue flame with no yellow tipping. Converting a range between natural gas and propane is a separate job (the manufacturer’s orifice kit and a regulator adjustment); ask when you book whether we can take it on. For a Gatineau address, gas work is confirmed at the time of booking.

Dual-fuel ranges (gas cooktop, electric oven) need both a gas connection and a 240 V circuit, so both parts of the job apply. If your kitchen has no gas line, we will tell you before booking that a licensed gas line installation is a separate job from the appliance hook-up.

Drop-in cooktops are a big part of kitchen renovations in Westboro, the Glebe and Centretown. A cooktop install starts with the cabinet cut-out: too small and the unit will not drop in, too large and it will not seal. An induction cooktop can need a larger circuit than the cooktop it replaces, so the circuit is checked against the spec plate before anything is connected. The unit is sealed to the counter, the clips underneath are tightened, and the wall oven or drawer below is checked for clearance. If you are pairing a cooktop with a new wall oven, we can install both on the same visit. For repairs to an existing induction unit, see induction stove repair in Ottawa.

An oven that will not heat often comes down to a bake element or an igniter, not a dead range. The usual causes are on our oven not heating in Ottawa page, and stove repair cost in Ottawa sets out typical repair prices. A diagnostic visit comes first, with the fee credited toward the repair you approve, and the technician gives you an honest repair-or-replace recommendation. If it is time to replace, book the installation with the same team.

A range installation is quoted in writing for you to approve first. Four things shape the number: electric versus gas, freestanding versus built-in, whether an old unit must be removed, and whether the outlet, cord or gas connector needs correcting. Nothing is added without your approval once the range is pulled out.

We book visits from 7 AM to 9 PM; outside those hours a $100 flat after-hours fee is added. Beyond 30 km from downtown Ottawa a travel charge may apply, and we confirm it when you book. Commercial ranges in restaurants are handled under our commercial service; see commercial oven repair in Ottawa and restaurant equipment installation.

Warranty terms for a range installation are confirmed with the quote; repairs carry our 3-month parts-and-labour warranty.

Ranges go in from Orléans, Blackburn Hamlet and Gloucester in the east to Kanata and Stittsville in the west, with Barrhaven, Nepean, Merivale, Alta Vista, Westboro, the Glebe and Centretown in between. In Gatineau we cover Hull, Aylmer, Buckingham and Masson-Angers in English or French; see appliance installation in Gatineau. B&M has been fixing and fitting ranges here since 1995.

Have the new range in the kitchen, still packaged, and leave the old range connected so the technician can see the outlet or gas valve. A photo of the outlet, attached to your request, tells us which cord to bring. For a gas appliance, say so in the request so the right technician is booked. For a cooktop or wall oven, have the cabinet cut-out dimensions or the old unit’s model number handy.

Kitting out a whole kitchen? Ask whether the fridge, dishwasher and range can be connected on one visit, with the washer and dryer added to the same trip. Same-day hook-ups happen when the schedule allows them, and your visit is set once we call or text with a window.