Induction stove repair in Ottawa

An induction cooktop has no burner element to burn out. Instead, an electronic power board drives a copper coil under the glass, and the coil heats your pan directly through a magnetic field. That is why induction faults look electronic rather than thermal: error codes on the display, zones that stop detecting cookware, cooling fans that run loud or not at all, and boards that cut out mid-cook. The good news is that almost all of it can be repaired without replacing the cooktop.

Cooktop won’t detect the pan. If one zone flashes and won’t heat, the pan sensor or that zone’s coil connection is the usual cause, assuming the cookware passes the magnet test.

Error codes on the display. Each brand’s codes map to specific faults: overheating sensors, supply-voltage problems, communication errors between boards. The code usually narrows the fault to one part, which the technician confirms with a meter before replacing it.

One zone dead, others fine. Typically a failed induction coil or its section of the driver board, repairable at the zone level on most models.

Whole cooktop dead or tripping the breaker. Points to the main power board, a filter board or the supply connection. We test before condemning any part.

Turns off by itself. Overheat protection, a failing temperature sensor, blocked cooling air or an empty-pan detection trip. If it happens repeatedly with normal cookware, book a diagnostic; sensors are an inexpensive fix.

Cracked glass. Replaceable on most models; we quote the glass against the cost of a new unit so you can make the call.

Loud or constant fan noise. Cooling fans keep the electronics alive. A failing fan should be replaced before it takes the power board with it.

The diagnostic starts with a known induction-compatible pan on every zone, then reads the fault code and the board’s stored errors. From there the technician tests the supply at the terminal block, the filter board, the power board and its IGBT switching transistors, each coil and its connections, the cooling fans, the temperature sensors and the touch membrane. Parts are replaced only once the failure is confirmed, and you approve a written quote first.

Induction cooktops are often paired with a built-in oven; see wall oven repair. For every other stove type, see our main stove and oven repair page, for radiant glass tops, glass top stove repair; and for gas cooktops and ranges, gas appliance repair.

Our rule of thumb: if the repair is less than half the cost of an equivalent new cooktop and the unit is under ten years old, repair wins. Induction units are expensive to replace, which tips the math toward repair more often than with conventional stoves. Either way, you get an honest written quote after the diagnostic and before any work; the $89 + tax service call covers the visit and the full diagnosis. For the decision on a whole range, see repair or replace your oven or range.

Bosch, Samsung, LG, GE and GE Profile, Frigidaire, Whirlpool, KitchenAid, Electrolux, Fisher & Paykel, Miele and other major induction brands sold in Canada. Brand pages: Samsung appliance repair, LG appliance repair, Bosch oven repair and Frigidaire stove repair. We serve Ottawa and Gatineau; on the Quebec side, see also stove repair in Gatineau.