Appliance repair in Beacon Hill

Beacon Hill is a settled east-end community of 1960s and 1970s bungalows, split-levels and detached homes, with townhouse communities near Blair and Ogilvie Roads, and home to many long-time families and retirees. Appliances here have often been in place for years, so we see a steady stream of ageing refrigerators, full-size laundry pairs, wall ovens and dishwashers that need repair rather than replacement, and we are glad to keep a good appliance running when the repair makes sense.

Every call gets an honest assessment: the technician tests the appliance, puts the price in writing and tells you plainly whether the fix is worth it. A common part often means the repair is finished in one trip. You can be served in either English or French.

• Refrigerator and freezer repair
• Washing machine repair
• Dryer repair
• Dishwasher repair
• Stove, oven and cooktop repair
• Wall oven repair
• Range hood repair
• Microwave repair

Brands we work on include Samsung, LG, Whirlpool, GE, Frigidaire, Maytag and Kenmore, as well as KitchenAid, Bosch, Electrolux, Miele and Jenn-Air. If an appliance is still under its original warranty, contact the manufacturer first.

Basement laundry and long vent runs

Many Beacon Hill homes keep the laundry in the basement, with a long dryer vent run and older plumbing. Slow drying is often a vent problem rather than the dryer, so we check both: airflow at the outside hood, the duct behind the machine and the dryer’s own heating circuit. Washers here tend to leak at worn fill hoses and door boots, and older top-loaders need lid switches, couplers and drain pumps.

Wall ovens and cooktops

Wall ovens come up often in our Beacon Hill calls, alongside separate cooktops. Typical faults are a failed bake or broil element, a temperature sensor that has drifted, a control board relay or a door lock that sticks after self-clean. Because a wall oven is built into the cabinetry, replacing it means finding one that fits the same cut-out, which often makes repair the practical choice.

Gas ranges, ovens and dryers

Our TSSA-certified technicians handle the gas work: burners that won’t light, clicking igniters, ovens that won’t heat and gas dryers with no heat. For gas appliances, the diagnostic is $129 + tax.

Newer appliances and error codes

Renovated kitchens bring newer appliances with electronic controls and error codes. Tell us the code when you book so the technician can come prepared.

Refrigerators that run warm

An older fridge that runs constantly yet stays warm usually has a dusty condenser coil, a failing condenser fan, or a defrost fault that has iced over the evaporator. On long-serving models, defrost timers and thermostats are frequent and inexpensive failures. The technician measures temperatures and tests each part before quoting anything. A compressor or refrigerant problem is sealed-system work: the diagnostic is $159 + tax and the repair is priced by phone.

Many homes here also run a second fridge or a chest freezer in the basement. Those units often go unnoticed until the food is soft, so if one is cycling constantly, sweating on the outside or icing heavily around the lid, it is worth having it checked before it fails outright.

Washers that won’t drain or spin

Standing water usually traces to a blocked pump filter or a pump that has failed; on front-loaders, coins, hair ties and lint pile up behind the lower front panel. On top-loaders, a hum with no draining often means a jammed drain pump, and a drum that won’t agitate or spin often comes down to a worn lid switch or a broken motor coupler. We also repair leaks and machines that stop mid-cycle.

Dishwashers that leave dishes dirty

A clogged filter, blocked spray arms or a weak circulation pump are the usual causes, with the inlet valve and heating element close behind. Leaks typically come from the door gasket or a loose connection under the tub, and a unit that won’t start often has a failed door latch or control.

Dryers that take two cycles

Before replacing parts, the technician checks airflow: a long basement vent run packed with lint is the most common reason a dryer needs two cycles, and it also makes the dryer run hot. If airflow is good, the heating element, thermal fuse or cycling thermostat is next on electric models, and the igniter or gas valve coils on gas dryers.

Ranges and cooktops

Coil-element ranges usually need an element, a receptacle or an infinite switch; glass-top models a radiant element or control. Ovens that bake unevenly typically have a weak bake element or a drifting sensor. With 240 volts at the terminal block, panels and wiring are best left to the technician.

Microwaves and range hoods

Over-the-range microwaves that won’t heat usually need a door switch, diode or magnetron; hoods with a dead fan or weak suction need a motor, capacitor or switch. We tell you honestly when a countertop microwave isn’t worth repairing.

A few safe checks can save a visit, or at least help the technician arrive with the right part:

• Power: make sure the appliance is plugged in and its breaker hasn’t tripped. Ranges and dryers use a 240-volt double breaker: if it has tripped, switch it fully off and back on once, and leave it off if it trips again.
• Water: for a washer or dishwasher that won’t fill, confirm the supply valves behind or under it are fully open.
• Filters: clean the dishwasher filter and the dryer lint screen; check the front-loader pump filter if you are comfortable doing so.
• Doors: a fridge door that doesn’t seal, or a washer or dishwasher door that isn’t fully latched, can mimic a bigger fault.

If the appliance sparks, smells of burning or leaks steadily, stop using it and unplug it, or switch off its breaker, until it has been looked at.

1. Request. Use the online form at any hour, or phone us; nothing is booked until we confirm.
2. Window. A call or text from us sets an arrival window of roughly three hours.
3. Inspection. The technician examines the appliance and tests the likely components.
4. Written price. The repair is quoted in writing on site, and the $89 + tax residential diagnostic counts toward it if you proceed.
5. Fix. Many repairs are done during that first visit; if a part must be ordered, we give you the expected timing.
6. Cover. The completed repair carries a 3-month parts-and-labour warranty, and you receive a written diagnostic report.

• Beacon Hill North
• Beacon Hill South
• Montreal Road
• Blair Road
• Ogilvie Road
• Rothwell Heights
• Cardinal Heights
• Gloucester Centre area
• Ottawa River Pathway

We also serve Cyrville, Castle Heights and Cardinal Creek, and the neighbouring areas of Blackburn Hamlet, Overbrook, Orléans and the ByWard Market. See all service areas.

A residential diagnostic in Beacon Hill is $89 + tax, and $129 + tax for gas appliances or commercial equipment. The amount is credited toward the repair you approve, and no travel charge applies here. Booking requests are accepted any time; service hours are 7 AM to 9 PM, and an after-hours visit between 9 PM and 7 AM carries a $100 flat fee. Each completed repair is covered by a 3-month warranty on parts and labour.

We have repaired appliances across Ottawa and Gatineau since 1995. For typical repair totals, see the appliance repair cost guide.