Dishwasher repair in Newmarket, ON

• Not draining. A clogged filter or sump, a blocked drain hose or air gap, a garbage disposer knockout plug left in, or a failed drain pump.
• Not cleaning well. Blocked spray arms, a dirty filter, a weak circulation pump, or water that isn’t getting hot enough.
• Leaking. A worn door gasket, a cracked sump or hose, a leaking pump seal, or suds from the wrong detergent.
• Won’t start, or stops mid-cycle. The door latch or switch, a control fault, or a float switch tripped by water in the base.
• Not filling. A closed supply valve under the sink, a failed inlet valve, or a stuck float.
• Dishes not drying. A failed heating element or fan, or a rinse-aid dispenser that’s empty or not working.
• Error codes. For example Bosch E15 (water in the base) or E24/E25 (drain faults). We test to confirm the cause.

Municipal water in parts of York Region is on the harder side, and homes on wells in the surrounding townships can be harder still. Scale builds up on spray arms, heating elements and inlet screens over time. When we see scale, we’ll point it out and tell you what helps, such as rinse aid, a cleaning cycle or a water softener check.

The technician checks the filter and sump, the drain pump and hose, the circulation pump and spray arms, the inlet valve, the heater, the door latch and gasket, and the control. You get the cause and a written price before any repair. The $89 + tax visit and diagnosis applies toward the repair if you go ahead.

Brands we repair

Bosch, KitchenAid, Whirlpool, Maytag, Samsung, LG, GE, Frigidaire, Electrolux, Kenmore, Miele and other common brands, including built-in and panel-ready models.

• Take out and rinse the filter at the bottom of the tub, if your model has a removable one.
• Check the drain hose isn’t kinked under the sink. If it was just connected to a new garbage disposer, the knockout plug may still be in.
• Make sure the hot water valve under the sink is fully open.
• Run the kitchen tap hot before starting a cycle.
• Write down any error code and the model number, found on the edge of the door.

Drain pumps, inlet valves, door latches, gaskets and filters are usually worth fixing. A failed control board or circulation motor on an older, lower-cost dishwasher may not be. We’ll give you the price and our opinion before any work starts.

Our Newmarket-based technician covers all of Newmarket, L3X and L3Y, with same-day service when a window is open. B&M Canada Appliances has been repairing home appliances since 1995. Common dishwasher repair requests in Newmarket:

• Dishwasher not draining
• Dishwasher not cleaning dishes
• Dishwasher leaking from the door or base
• Dishwasher not starting or not filling
• Dishwasher error codes
• Bosch, KitchenAid, Whirlpool, Samsung, LG and Miele dishwasher repair
• Built-in and panel-ready dishwashers

We also repair dishwashers in Aurora, East Gwillimbury, Oak Ridges and the rest of York Region, as well as nearby Bradford. For fridges, washers, dryers and ovens, see appliance repair in Newmarket.

1. Call us or send a service request with your Newmarket postal code, the appliance, brand, model number and symptoms.
2. We call or text to confirm a time window of about three hours. Your request isn’t an appointment until we confirm it.
3. The technician diagnoses the problem and gives you a written quote.
4. If you approve, we repair it on the spot or book a return visit for parts. The repair has a 3-month warranty on parts and labour.

Our York Region service is residential only, and we don’t take overnight emergency calls here.